answersLogoWhite

0

If it's the 3.1L motor, it's just below and to the right of the Power Steering pump. If it's a 2.4L QUAD4, it's on the backside of motor just underneath the exhaust manifold, very dumb location.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the location of a water pump on a 1995 buick skylark 4 cylinder?

The location of a water pump on a 1995 Buick Skylark 4 cylinder is next to the engine. It is found directly under the alternator.


Where is the water pump located on a 1994 Buick Skylark?

on the back of the engine down bottom. gm Jim


How do you replace the water pump and where is it located on a 1996 Buick Skylark V6?

How do you replace the water pump and where is it located on a 1996 Buick Skylark V6


Where is the water pump located on a 93 Buick Skylark?

The water pump on a 1993 Buick Skylark is located on the front of the engine block, typically on the passenger side. To access it, you may need to remove the serpentine belt and other components, such as the engine cover, depending on the specific configuration of the engine. It's advisable to refer to a repair manual for detailed instructions specific to your vehicle.


Is there a difference in 97 and 98 buick skylark 3.1 v6 water pumps?

No, it's the same engine so it should fit.


Where is the water pump located on the 1995 buick skylark quad 4 engine?

On the 1995 Buick Skylark with the Quad 4 engine, the water pump is located on the front of the engine, near the timing cover. It is driven by the serpentine belt and is positioned to the left side when facing the engine from the front. To access it, you may need to remove the serpentine belt and possibly other components depending on your specific setup.


How can you bypass heater core on 1988 Buick Skylark?

You can bypass your 1988 Buick Skylark heater core by removing the heater core water supply hoses. There will be to water hoses. Connect the water hoses to each other.


What could cause the engine to over heat on a 1990 Buick Skylark?

I would say that you are losing coolant somewhere hoses,water pump,radiator.


Why might the cooling fan not be working on a 1990 Buick Skylark 2.5 engine?

I had the same problem with my 90 buick century, Replacing the temperature sensor did the trick, it is located above and behind the water pump.


Where is the thermostate on 4cyl Buick skylark?

The thermostat on 4 cylinder, 2.3L Buick Skylark is on the bottom of the water pump. Remove the metal water line connected to the bottom of the water pump to find it. Remember the new O-ring with the new thermostat.


Where is thermostat located on 93 Buick Skylark?

On a 1993 Buick Skylark, the thermostat is located in the engine's coolant outlet housing, which is typically found at the engine's front, near the water pump. To access it, you'll need to remove the upper radiator hose and the bolts securing the thermostat housing. Once removed, you can replace the thermostat itself. Always ensure the engine is cool before attempting to service the thermostat.


Where does the water come out of the windshield washer on your 1995 Buick Skylark.?

From hoses attached to the wipers.