Want this question answered?
1998.5-2003 it is on the part under the hood where the throttle cablesd attach. 2004 it is under the driver side battery box 2005-2013 it is part of the accel pedal itself.
It contains two potentiometers.
The APP sensor is located on the right side of the upper end of the accelerator pedal * Disconnect the negative battery cable * Remove the knee bolster * Disconnect the electrical connector from the APP sensor * Remove the APP sensor and pedal assembly mounting nuts and detach the assembly from the firewall
what is location of cam positioning sensor on 2005 scion xb
The 2005 Nissan Quest OBD 2 port is under driver side dash above accelerator pedal
Generally speaking the throttle position sensor is on the throttle body.
knock sensor location
on the muffler
The 2005 Toyota Highlander OBD 2 port is on lower edge of dash, over accelerator pedal"
I'm not 100% sure, but try the right side kick panel. (the little panel in front of the door, under the dashboard) Or another way of explaining it's location is to the right of the accelerator pedal.
Warm up engine. - Put in neutral (n)! -Make sure everything is off (RADIO, AC, ETC.) -Turn ignition switch ?OFF? and wait at least 10 seconds. -Confirm that accelerator pedal is fully released, turn ignition switch ?ON? and wait 3 seconds. -Repeat the following procedure quickly five times within 5 seconds. a. Fully depress the accelerator pedal. b. Fully release the accelerator pedal. -Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 20 seconds until the MIL stops blinking and turned ON. -Fully release the accelerator pedal within 3 seconds after the MIL goes ON. -Start engine and let it idle. -Wait 20 seconds.
Decrease pressure on the accelerator pedal, or downshift, in order to reduce your speed. Warning light will be extinguished.