what part of motor is the knock sensor located on 1996 Chevy S-10 4 cyl.
passenger side of engine block
4.3L, behind engine, on top,
It is screewed into the side of the engine over by the starter.
It does not have 1
Where is the Knock Sensor located on a 1996 Oldsmobile Aurora?
The "knock sensors" for the Avalon 3.0 are facing the firewall on the engine block just below the cylinder head ,their are two knock sensors .
The knock sensor is located on the side of the engine block near the bellhousing
The knock sensor for a 1996 200sx is located on the passenger side of the engine. It is located under the intake manifold.
if its not that and its not turning then its the starter. if its not that then it can be the spark plug make sure its not wet
how you can remove the knock sensor from a 1996 Nissan pathfinder i need a picture
It is screewed into the passenger side of the engine just in front of the starter. It is hard to see.
IAT sensor location would be located on the Intake duct is a black 3-4" tubing. that comes out of you air filter box to you intake manifold.
I drive a 1995 Ford Explorer and as far as I know it doesn't have a knock sensor My Haynes repair manual engine wiring schematic shows a knock sensor on the 1996 Ford Explorer - OBD II / EEC V system