were is the crankshaft sensor located on a 1987 Pontiac Grand AM with a 2.5L engine
depends on the motor mine is a 3.3 liter and is located behind the harmonicf balancer by the crankshaft
there isn't a crankshaft position sensor on a 3.8l motor in a 1999 Pontiac grand prix according to the manual
where is the crank sensor located on a ford e250 1999
Hi The CAMshaft position sensor on the v-8 4.7 liter engine is on the front right side (passenger) of the engine bank. The CRANKshaft sensor is behine the stater motor on the passenger side
The crankshaft position sensor is located on the engine block above the starter motor on all 4.7L V-8s. The starter motor must be removed in order to service the sensor. If your jeep is equipped with a front axel skid plate it must also be removed. The starter motor (and Crankshaft Position Sensor) are located at the rear of the engine very close to the transmission bell housing Good luck !!
LOCATION OF CRANK ANGLE SENSOR ON 2003 4.7 PETROL MOTOR
2006 dodge stratus 2.4 XST, the crank sensor is located under the starter motor, must be removed the starter motor in order to change this, just now I did that job
Crankshaft sensor is on the back of the bell hosing of the transmission and the camshaft sensor is behind of the motor mount on the left under the coil pack
behind the crankshaft pully at the bottom of the motor and on the back of the block
The crankshaft sensor is located on the side of the motor towards the firewall. It is located more towards the oil filter,
In my 01, it's a camshaft sensor under the transfer pump. On some, behind the starter motor in the block. It depends on the year model--get a Haynes manual for your year.
where is the location wiper motor Pontiac grand prix 2002
the crankshaft sensor is behind the cylinder head on the top of the bell-housing (where the motor and transmission bolt together)
left bank of motor on the bell housing
if it is a zetec engine the crankshaft sensor is underneath the starting motor
on the back of the motor wright below the crank sensor
if it is a 2.4 "x" motor, the crankshaft position sensor should be located in the front of the motor "TUCKED" up behind the starter. it is very difficult to find, but it s there.
The 1999 Cadillac crankshaft sensor is located on the same side of the motor as the alternator. It is on the side of the block about half way between the front and the back.
The crankshaft position sensor on a 3.5L Chrysler Pacifica is located next to the motor, toward the rear. It can be found next to the transmission.
its located above the starter motor.
its located in the distributor.
on the left lower side of the engine block
in top frount of the bell housing drivers side motor
How to change blower motor on 2000 grand am gt