To answer this i will need to know whatsize engine you have.
No Crank Sensor until 1992
It does not have a crank sensor.
That year model does not have a crank sensor.
I have a 1992 Pontiac Sunbird with 2.0 four cylinder in it, just found the crank sensor on it, to replace it. It is located on the FRONT side of the engine, below exhaust manifold and just above the A/C compressor. HOPE THIS HELPS SOMEONE ELSE!
Its located on the radiator passanger side about 3" below the radiator cap.
No crank sensor. Only has the distributor pick up plate.
Yes, a 1992 Pontiac Grand Am does have a timing belt. Diagrams can be found of them on the internet with a simple search.Ê
There is a little spacer that the dealer sells that is glued to the end of the crank sensor before instillation. That is the gap setting.
Dodge Dakota V6's didn't have a crank sensor until 1992.
in the dist.
how to chang spark plugs in a 1992 Pontiac grand prix
That year model did not use are have a crank sensor.
sounds like flooding Could be the Crank Position Sensor, especially if it won't restart for an unpredictable period of time.
1992 Pontiac grand am ac relay locationi found the relays. they are in the center of the firewall next to the blower case. they are in a case with cover that is bolted to the firewall.
idle air control motor.
My 1990 Lumina 3.1 had the same problem and it was caused by the crank sensor.
Answerthe intake air temp sensor is located in the air duck.probably right after the air filter box.
firing order: 1-2-3-4-5-6 with clockwise distributor rotation on the 3.1 v6 ohv engine
established equal rights for women
There was more than one size used on the 1992 Pontiac Grand Am depending on which model it was GT, etc. It should be listed on the drivers door post. If not click the link I will post.
in the tank
the sensor is located in the differential housing on the back of the transmission. (this is the speedomoter sensor, it is in the housing that the pass axle shaft slides into) For the 3.3/3.8L, it is near the bell-housing facing the firewall, as it senses the magnets that are on the torque converter when it spins. (that is the engine speed crank position sensor)
It is behind the harmonic balancer.