Your Answer
Related Questions
91 Dakota crank sensor location 3.9 v6?
No Crank Sensor until 1992
Locate crank sensor on Dodge Dakota 1993?
top of bellhousing
Where is a crank sensor located for a 1990 Dodge Dakota?
Inside the distributor
Where is the crank position sensor on 1990 Dodge Dakota 3.9L?
No crank sensor on a 1990, only the pickup plate (cam sensor) in the distributor. how about a 1991?
If the crank position sensor 1998 Dodge Dakota magnun v6 is not work what would happen?
If the crank sensor is not working, the engine will not run.
Crank sensor location 95 dodge 5.2l?
Dont know
Location of cam sensor on a 2000 dodge Dakota 4.7l?
Under the front of the right cylinder head. If you look up from underneath you can see the three wire connecter. ************please note that this answer is wrong...this is the location of the CRANK SHAFT SENSOR****************
Dodge Dakota crank sensor what is it for?
most crank sensors are for engine timing with the cam shaft, the distributor on at least 97' dodge and newer controls fuel timing.
Does a 1995 dodge Dakota with 2.5 L have a crank shaft sensor?
No, just the distributor pick up plate (cam sensor)
Crank sensor location 5.2 1995 dodge 3500 Ram Van?
On the bellhousing
Crank sensor dodge 1989 3.9 location?
That would be the pick up plate in the distributor.
Crank positon sensor 2006 dodge sprinter location?
It is in the bellhousing on the driver side , near the starter.
What does a 1989 3.9L Dodge Dakota crank sensor look like?
A 1989 Dakota uses the distributor pick up plate for the crank signal. It is the plastic plate under the rotor inside the distributor cap.
Where is the Location of crank shaft sensor 95 dodge Dakota?
The crankshaft position sensor is located at the rear passenger side of the engine, next to the flywheel. On V6 and V8 it is below the spark plug wire loom, near and slightly higher than the EGR tube / exhaust manifold junction.
I have replaced my coil pick up coil and checked the fuses on my 99 dodge Dakota with no spark where do i look now?
crank sensor
Where is the crank position sensor on a 1998 Dodge Dakota 5.2L?
Top of the bell housing, pass side, behind the cylinder head.
Do you need a crank sensor on a dodge stratus?
Yes. The crank sensor tells the coil when to fire.
97 Dodge crank sensor And cam sensor location at?
IS this a 5.2, if so the crank sensor is on the passenger side of the engine, in the far rear, it picks up off the flywheel, the cam sensor is located inside the distributor (it is the pick up coil).
Where is the crank sensor on a 1993 Dodge Intrepid?
where is the crankshaft sensor located on a 1993 dodge intrepid
What is the location of cam sensor for 08 dodge cummins?
Lower/front/driver side of the block. The one aiming at the crank pulley is the crank sensor. The cam sensor is just above it.Lower/front/driver side of the block. The one aiming at the crank pulley is the crank sensor. The cam sensor is just above it.
What is the Location of crank shaft sensor 1992 Chevy truck?
That year model does not have a crank sensor.
Where is the Location of crank sensor on 1998 Dodge Dually 3500?
12 valve engine: front above the crank pulley 24 valve engine: behind the starter.
Where is crank sensor located on 1997 Dodge Ram van?
the crank sensor is located on the top front of the tranny
Were is the crank sensor in a 1993 dodge caravan 2.5?
It does not have a crank sensor, it only has the "pick up" plate in the distributor.
Crank sensor location 84 Chevy 2.0?
They did not use a crank sensor in 1984, There was no need for 1
