No, just the distributor pick up plate (cam sensor)
most crank sensors are for engine timing with the cam shaft, the distributor on at least 97' dodge and newer controls fuel timing.
Yes
It's on the passenger side of the bellhousing.
I have a 1995 dodge Dakota that didnt fire either first go for the cheaper step and check the fuses if its not that check the crank shaft sensor that is what mine turned out to be. it was only 60 dollars for the part and 5 minutes of my time.
try crank position sensor and cam shaft sensor
It is in the side of the block behind the starter.
try taking the ignition control module to oreilly's to have it tested. How long ago were the plugs wires cap and rotor replaced?
Under the front of the right cylinder head. If you look up from underneath you can see the three wire connecter. ************please note that this answer is wrong...this is the location of the CRANK SHAFT SENSOR****************
Where is the crank shaft sensor located in a Audi a6
A bad cam or crank sensor can cause a no start, but the engine will still crank or turn over.
The crankshaft position sensor is located on the top of the transmission. It is located close to the bell housing.
crank shaft posetion sensor