The low Pressure service port is located on top of the accumulator located pass side up by the firewall. Black screw-on cap. (blends in very well to everythign else. right-hand threads. Tight fit for some gauges.
30-50
When recharging your AC you should first inspect your ac lines for leaks. Remove the cap from the low pressure side service port, and look at the connectors on the air conditioner lines. Remove the cap from the Low Pressure Side service port. Locate the connectors and connect the refill hose. Open the valve on the refill hose and fill.
Low pressure port Larger line from the compressor
The one near the firewall.
one port is in the front pass side the other is on the canister near the fire wall
Most Dodge vehicles ( a 2005 Ram included ) use manifold absolute pressure sensors, MAP sensors.
Low oil pressure
The low pressure port of the A/C system usually has a blue or black dust cap and is located either on the larger diameter metal tubing typically found between the evaporator and compressor, on the compressor itself, or on the receiver drier (orifice tube systems only). The high pressure service port is found either on the smaller diameter tubing or the compressor and is larger in diameter. Only charge through the low pressure port.
A dual port RAM failure is quite unusual in a computer system. It means that the RAM ports or slots have failed or likely shorted out.
Yes, just be sure to swap the tire pressure sensors if you want the warning light to go out.
One has 3 one has 8
The difference between single port RAM and dual port RAM is that single port RAM can be accessed at one address at one time, thus you can read/write only one memory cell during each clock cycle. Dual port RAM has ability to simultaneously read and write different memory cells at different addresses. SPRAM uses a 6 transistor basic ram cell, while the dual port ram cell uses 8 transistor cell for memory. so the area of spram is much smaller than the area of dpram cell. To gain the advantages of both spram (less area) and dpram ( high speed) Pseudo dual port ram is introduced. which can read and write the data in the same clock, using rising and falling edges for the operations respectively, and using spram memory cell for the storage of data.