Located on top of the A/C dryer located on the passenger side fire wall
The switch is under the dash connected to the push rod for the clutch master cylinder.
35 or 39 PSI
May be on the upper end of the clutch pedal under dash area
The oil pressure switch on a 1989 Chevy Camaro RS is located on the bottom of the engine hear the oil filter. It constantly monitors oil pressure and updates the computer on its status.
all depends if you do it your self or not if you do it the kit will run you about $250.00 that is the release bearing, clutch and pressure plate
Yes, this switch must be activated to allow the engine to start. If this switch has failed, it may function improperly or not at all.
Flywheel must be torqued to 105 ft/lbs. Clutch and pressure plate torqued to 22 ft/lbs.
There is a CEL, Check Engine Light, on the 1989 Thunderbird.
It's located under the dash wher the clutch peddle is attached to the hinge. It's fight next to the break sensor.
It requires a special socket to fit it.
the oil pressure switch is located in the rear of the engine compartment on the drivers side under the valve cover
The clutch safety switch is located on the linkage attached to the pedal,approx. 6" up from the pad, however if your f-150 has cruise control,the cutout switch and the clutch safety switch are often a common switch(meaning that both switches are built into one unit) also you did not specify what year your truck is.with-out the year and the options I cannot tell you which wires you need to connect to by-pass the switch. Of course the switch was put there for safety reasons and should not be eliminated