The front main is behind the crank pulley. The rear main is behind the flexplate/flywheel. The trans has to be removed to access this one.
Mains 85------- rods 45
The 1999 Saturn main bearing cap torque specifications are 160 pounds per square inch. The main bearing cap bolts should be torqued in 40 pound intervals.
5-6 hours
It is on the front of the crank shaft. It seals the oil at the crank pulley.
The main difference is in the length of the vehicle, the Grand Caravan (Long Wheel Base) being longer than the regular Caravan (Short Wheel Base). For example the 2001 to 2007 models, the SWB: is 113.3 in (2,878 mm) long and the LWB is 119.3 in (3,030 mm) long.
It's on the drivers side, between the battery and the right fender.
The 1996 Dodge Intrepid main bearing torque specification is 180 pounds. The main bearings should be torqued in 60 pound intervals.
There is one on each end of the crankshaft. The front main seal is at the pulley and, while the rear main is at the transmission end.
All main bearing caps should be tightened to 85 foot-pounds.
The P1745 code in a Dodge Caravan is for high pressure in the transmission line. It is normally caused by a bad solenoid pack or a main regulator valve stuck in the valve body.
it is part of main comp and runns 300 new i would recomend junk yard for 1
dodge caravan is the main one...