The crank shaft sensor on a 2000 Chevy Suburban is located on the bottom of the engine, near the oil filter. It constantly monitors the crank shaft and updates the vehicle's computer of its status.
It is in the passenger side of the timing cover towards the bottom.
fuel shut off sensor located on Chevy Malibu
It has 4 of them screwed into the exhaust system/pipes.
Where is the reset button on a 2000 Chevy suburban
Next to the gas pedal
How do you change a tire on a 2000 chevy suburban
IT does not have a reset switch.
The knock sensors(2) are in the valley pan beneath the intake manifold
usually 02 sensors are located on the catylac converter OR the manifold
Rear of tranny
The fuse or relay for the power windows on a 2000 Chevy Suburban is located in the fuse box on top of the battery. Unplug the old relay and insert the new one.
It is in side the gas tank.
That should be the sensor located after the catalytic converter.
It is in the tank with the pump.
The fuel level sensor would be located in the fuel tank.
heater sensor circuit Chevy astro 2000
no it does not.
it is behind the starter. You will have to remove the starter to get to it.
6x139.7(6x5.5) suburban 2000-2006
NO it must have it.
Bank 1 on a Chevy is the drivers side. Sensor 1 is located in front of the catalytic convertor and sensor 2 is after the converter. Each side has 2 O2 sensors.
On the very back of the oil pan.
There are several circuit boards in that vehicle. Need to know which one you are looking for.
if you cant figure it out you shouldn't be trying to replace it