0
if you have the vortex engine you are going to have to remove the plastic peice over the intake and what not( v8 engine) then you will see a medal place towards the back if you remove the 3 screws from it then you will see the map senser there. it is fairly easy to remove make sure to put the retaining bolt back in it
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Fuel sensor 2000 GMC sierra?
Yes, there is a fuel sensor in a 2000 GMC Sierra.
Where is the cam shaft sensor located on a 2000 GMC sierra 1500?
Type your answer here... Where IS Cambshaft sensor in 2000 gmc 1500 and what does it do
Where is the crank shaft sensor on a 2000 GMC sierra located?
in the side of the block, above the started
Where is the IAT sensor located on gmc 2000 sierra 5.3LITER?
The IAT Sensor is attached to the Mass Air Flow Sensor that is attached to your air filter box.
Where is the coolant temperature sensor on a 2002 gmc sierra?
The 2002 GMC Sierra: temperature sensor is located on the front of the engine. The sensor will be just above the thermostat housing.
How do you change the oxygen sensor 2000 gmc sierra?
How do you rebuild a differential for a 1981 GMC pickup?
Where is the camshaft position sensor located on a 1997 GMC Sierra?
its located in the distributor at the back of the motor.
Where is the vehicle speed sensor located on a 1995 gmc sierra?
its located next to the drivers side front tire, by the brakes
Where is the knock sensor located on a 2006 gmc sierra 1500 4wd 5.3 L?
On engine block
Where is the fuel sensor located on 2000 Gmc Jimmy?
fuel tank.
Where is the Knock sensor in a 2000 GMC Sierra?
they are located under intake manifold The #1 sensor is located in the front of the engine and the #2 sensor is located in the back of the engine. Remember to replace the intake gaskets once you replace the sensor/s. The total time it took me to pull the intake and locate the bad sensor was about 6 hours. Hope this helps
Where is the Oxygen Sensor on a 2000 GMC 1500 Sierra truck?
There are 4 o2 sensers they are located on both ends of the catalytic converters. They look like spark plugs sticking into the exhaust pipe.
