Chevy Silverado
Mazda Protege
Ford F-150

Where is the modulator valve on a 1994 Mazda Protege DX?

414243

Top Answer
User Avatar
Wiki User
Answered
2011-09-13 10:59:01
2011-09-13 10:59:01

where is the modulator vavle on my 1994 Mazda Protege dx?

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


A 1994 Plymouth does not have a modulator valve.


Yes the 1994 Mazda Protege is a OBD 1 port


Never heard of a modulator valve on a caravan is it for the trans? Chrysler transmisions do not have modulator valves


That year truck does not have a modulator valve on the transmission. it has a electronic transmission in it.


The starter, on a 1994 Mazda Protege, is located on the driver's side of the engine. It is just behind and to the right of the oil fill cap.


No, it has motorized seat belts. The 1994 Protege is essentially the same car as the 1990 Protege, which is an economy car that cost about $10,000 new.


On a 1994 Ford Explorer : The modulator valve is on the outside of the A4LD automatic transmission , on the passenger side of the transmission , I believe it is behind a heat shield


The first Mazda Protege, also called the Mazda 323 and the Sixth Generation, was manufactured in 1989, and the car's production lasted for six years until 1994.



the alternator is located under the inlet manifold


No, that transmission is electronic controlled by the PCM.


6.5 inches. No screw patters match the protege, you'll have to drill alittle bit.


On the top of the transmission, with a harness headed to it, should be about 3 bolts to take off, then valve comes off... shift solenoids are in there


The only tool that is really needed to remove the distributer cap off of 1994 Mazda Protege is a screwdriver. Using this tool will enable you to loosen the cap, and then you can remove it.


Have your Mazda dealer parts department print out a picture of the relays location for you. They will do this if you ask them.


Behind the engine, under neath the intake manifold.


assuming your talking about the transmission modulator...visually inspect the transmission and look for a vacuum hose from the engine to the tranny...


Email me for the Fuse diagram dwillman@canada.com


On a 1994 Ford Explorer : The modulator valve for the A4LD automatic transmission is on the passenger side of the transmission ( I believe it is behind a heat shield )


is under the transmission stick console, heres a web page for mre info. http://www.scribd.com/doc/51604740/Mazda-Protege-Workshop-Manual-1994-1998R-English


There are a few reasons why a 1994 Mazda Protege won't start, but does crank. A couple of reasons could be the air flow sensor or a problem in the fuel lines.


When you remove the caliper, the pads can be pressed out by hand.


Transmission Modulator Valve? Location=Right hand side of the transmission close to the rear .Covered by a heat shield because of the heat from the exhaust.Do not lose the pin after removal.Verify replacement modulator .Make sure it's your type.C3 transmission modulator look almost identical.Verify measurements at pin location .


underneath the green and red stripy cats hat by doctor seus




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.