0
Under the dash on the steering column or bolted to the side of the floor shifter
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the neutral safety switch on a 1978 Ford F250?
it is on side of transmission
How do you change the neutral safetey switch in a 1978 Chevy Malibu?
When you learn how to spell safety right I'll help you
Where can you find a wiring diagram for the backup lights and neutral safety switch for a 1978 Malibu?
Go to a parts house that carries a Haynes Manual. They have them for specific cars.
Neutral light on 1978 goldwing not coming on?
most likely neutral switch but check bulb first neutral switch is located right front under lower frame tube behind exhaust pipes
Where is the neutral switch on 1978 Honda gold wing?
rigth side under frame (when sitting on bike)
What actors and actresses appeared in Trans - 1978?
The cast of Trans - 1978 includes: Carol Warner as Solo - dancer
Are the frames on a 1978 Malibu and a 1978 Trans Am interchangeable?
Considering the fact that the Trans Am is a unibody and the Malibu is a full frame car...NO
Where is your Trans dip stick on a 1978 Trans am?
.The 1978 Pontiac Trans Am engine oil dipstick can be found on the right hand side of the engine. The engine oil dipstick will have a yellow handle.
What are the release dates for Safety In Danger Out of Doors - 1978?
Safety In Danger Out of Doors - 1978 was released on: USA: 1978
What year was the Trans Am in sleepwalkers?
1977/1978
How many 1978 Trans Am Y88 made?
For the 1978 Trans Am Y88 S.E. L80, the number of units produced was 880. For the 1978 Y88 S.E. W72, the number of units produced was 7,786.
1978 Chevy K10 neutral safety switch location?
The neutral safety switch is located on the steering column where it passes through the firewall on the inside. There are four wires coming out of it. To access it you must remove the small lower dash panels under the steering column, remove nuts holding steering column up to dash, remove four bolts that hold the bracket to column, remove ignition switch mounted on top of column, unplug large plug to lower right of ignition switch on steering column, pull switch out of way while paying attention to ignition switch rod coming from actual key switch and how it goes together. Not sure how to actually remove switch, but I don't think it is too hard. It is a relatively inexpensive part, hardest part is reaching it without tearing more apart. Shouldn't be to big of a problem all in all.
