I have to assume you are talking about an automatic TJ, in which case it is on the passengers side of thetrans, about mid way up, it has a large nut toward the middle of the top, and two bolts, one on either side, you can loosen them and rotate it to adjust the switch.
The neutral safety switch is located on the transmission, passengers side.
Put your trans in neutral and move the second ( 4wd) shifter into the desired 4wd mode.
The neutral safety switch and backup light switch are one in the same. You have to replace it. It is located on the transmission where the shifter connects to it.
Usually it is located on the shifter inside the console. You have to disassemle the console around the shifter to get to it.
Many reasons, but a common one is a faulty neutral safety switch, try starting it in neutral.
You may have to remove the shifter and realign forks in the top of transmission--problem usually caused by wear
No. A Jeep Wrangler does not have an inertia switch.
what is the switch located in the battery tray on a 98 jeep wrangler
A 2002 Jeep Wrangler does not have a reset switch.
Bolted to the floor in front of the shifter.
more specific please. shifter handles should just unscrew.
Should be on the left side of the trans right around the shift lever it will have a connector with 3 pins the one in the center is the neutral switch it is also the backup light switch.