0
Quote:
"Left side of dash, 6 way rectangular connecter."
You will find it right behind the lower right part of the dash on the drivers side near the center console or ash tray. It is a blue connector attached to the knee bolster.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What does done stand for on a Dodge 2000 Intrepid?
Self test has completed.
1995 Dodge Intrepid es synchronize camshaft signal?
test
How can you test a 1995 Dodge Intrepid computer module?
apa yg dimaksud kemiskinan?
How do you test a crank position sensor on a 2000 Dodge Intrepid?
scanning for codes will indicate if the CPS is at fault.
Where is the 1994 Dodge Intrepid speed sensor located Would that cause the speedo and Tach to stop working?
check all of your fuses all you have to do is do an ohm test probe one side and the other side you dont even have to take them out
Where is Obd II test port located on a 1994 Toyota truck?
1994 Toyota pickups do not have obd II they have obd I. There is a " diagnostic port " under the hood but its not of much use.
Dodge intrepid Fuel Pump test?
take the gas cap off the gas tank and have someone listen for it to turn on as you turn the key onto start.
Why does my 1995 Dodge Intrepid still bring up a map sensor code when i have replaced it and the car still runs poorly?
You need to test the wires at the map.
How do you test a cooling fan relay on a 1997 Dodge Intrepid?
All the relays are the same. Just swithch it with the fuel pump relay and if the car runs, the relay is good.
Where is the fuel pressure test port on 2004 intrepid 3.5?
Find the fuel line or where the fuel injectors are and fallow the fuel line they are connected to and at some point you will find a connection much like a tire connection that is where you will do a fuel pressure test from
Why did the dashboard lights on my 1999 Dodge Intrepid stop working?
If all of them stopped working at once, it could be a fuse. Find the Fuse box and test the one that connects to your dash. if the fuse is bad, replace it.
Where is the diagnostic port on a 1994 Ford Ranger?
On a 1994 Ford Ranger ( which is OBD I , EEC IV ) should have an EEC TEST connection in the engine compartment ( P.S. I'm not a mechanic / technician )
