The oil pressure sending unit, on a Chevrolet 4.3 liter V-6 engine, is located on the left side of the engine, just above the oil pan. The sensor is near the front of the engine.
At the rearmost section of the engine to the right of the distributor.
Where is the oil sending unit located on the 2001 Chevy 43. vortec engine?
On a 5.7 V8 engine, the oil pressure sending unit is on the back of the engine block next to the distributor.
where are the temperature sending unit located on a 1990 Chevy engine 5.7
The oil pressure sending unit on a 4.3 engine is located on top of the engine, at the very back of the engine, next to the distributor on the drivers side. I remove the distributor to gain better access to the sending unit.
The oil pressure sending unit is located under the hood, way in back of the engine, under the distributor on the drivers side. Removal requires removal of the distributor.
It is located right behind the intake,sticking straight up.If your sitting in your truck look right at the middle of ur windshield it will be located right in that area on the engine.
It is the switch at the very back of the engine where the engine and transmission meet. and just to the driver's side of the distributor
The OPSU on a Chevy 6.0 is located on the back of the engine, on the right side behind the manifold. It is a little bit difficult to access, but it is there.
Top, rear drivers side of engine, below the distributor. Removing the distributor gives you room to R&R the oil pressure sending unit.
The oil pressure switch on a 1997 Chevy Tahoe is located on the back of the engine. It is in the center-rear part of the engine.
Where is the fuel pressure regulator located on a 1989 chevy silvarado with 5.7 liter engine