REMOVAL & INSTALLATION
See Figure 1 (It is below the Power Steering pump on the back corner of the engine) # Disconnect the negative battery cable. # If necessary for access, raise and safely support the vehicle. # If necessary, drain the engine oil into a suitable container. # Detach the switch electrical connector. # Remove the switch. To install:
# Coat the first two or three threads with sealer. Install the switch and tighten until snug. Engage the electrical lead. # Carefully lower the vehicle. # Fill the crankcase with the proper type and amount of engine oil. # Connect the negative battery cable.
Code P0452 on a 1998 Buick LeSabre indicates a fault with the fuel tank pressure sensor. This sensor measures the pressure inside the fuel tank and helps monitor the evaporative emissions system. The issue may be due to a faulty sensor, damaged wiring, or issues with the fuel tank itself. It is recommended to have the sensor and its wiring inspected and tested to determine the exact cause of the problem.
32-35 psi
The 1998 Buick LeSabre solenoid can be found on the firewall in the engine compartment. There will be three solenoids on the firewall.
How do you install a heater core on a 1998 buick lesabre
The Crank sensor in my 91 LeSarre Limited is behind the Harmonic balancer pulley....there are fins on the back of the pulley that line up with the sensor.
the 2 digit code 13 means- problem with oxygen sensor or circuit
no
The 1998 Buick LeSabre custom sedan has a curb weight of 3,443 pounds. It has a wheel base of 110.8 inches and a ground clearance of 5.5 inches.
165432
10 30
yes
Dex cool