Want this question answered?
Pressure switch on a 2005 Chrysler 300 C can be changed by removing the wires from the switch. Remove the retaining nut. Reverse the process to install the new switch.
A 2005 Chrysler Sebring does not have a reset switch.
were is the oil pressure sensor located
I want an answer
It is inside the valve body, inside the transmission.
above starter
A 2005 Chrysler Sebring does not have a distributor.
On the back side (firewall side of the engine) a few inches above the oil pan, near the above a cv joint. Its best approach is from under the car.
A Chrysler Sebring does not have an inertia or reset switch.
Chrysler vehicles are not equipped with an inertia switch.Chrysler vehicles are not equipped with an inertia switch.
On the 6.0L it is located on the back of the engine block below the valley/intake manifold.
Chrysler products do not have kill switches.Chrysler products do not have kill switches.