Dextron/Mercon.
the crank sensor is located on the back of the engine aprox. 1 inch above the oil pan. there is one bolt holding it in place, after removing the bolt pull the sensor out installation is reverse
It requires a special socket to fit it.
could be tps or throttle positioning sensor
no there is not,if its automatic than its the trans cooler
There is a low level sensor in the side of the oil pan. It is either stuck or defective.
right above the oil filter
right above where the oil filter is located
yes it does- it is to the right of the oil filter.
It is next to the oil filter.
Drain oil first, then remove the bolts that hold it up you will need a 10MM and mm Socket with extentions...
There is no oil tank on any Beretta ever made.