Want this question answered?
Temperature Gauge Sending Unit The sending unit is located in the front section of the manifold in the vicinity of the thermostat.
The Oil Pressure Switch or Oil Sending Unit (which ever you prefur calling it) on 2.5L its located about underneith the Thermostat Housing.
Unless this is a brake by wire system the switch should be located on the upper end of the brake pedal arm.
It is located behind the distributor.
behind the oil filter
it is located behind the distributor on top of the block there is the oil sending unit and a oil sending switch with a wire that goes to your choke if it is electric trace it back and you will find it...
On the 4.0 L OHV engine, the oil pressure sending unit is on the driver's side of the engine, located below the power steering pump.
The Oil Pressure Switch (Oil Sending Unit) is located on the rear of the motor towards the top. The crank sensor is located next to it if that helps any.
The oil pressure sending switch on a 1988 Chevrolet Celebrity with 2.8L V6 is located on the bottom of the block near the oil filter.
Are you refering to the Temperature Gauge Sending UnitThe sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.
The oil pressure switch is near the oil filter and the water temperature sender is located near the thermostat housing. The fuel sending is in the fuel tank mounted on the fuel pump module.
The fan sending unit is on the side near the thermostat housing.