THE AUTOMATIC TRANS OIL TEMP SENSOR IS LOCATED ON THE A/T VALVE BODY BEHIND THE PAN.
tiburon 2.0 Intake air temperature (IAT) sensor lokation?
where is the coolant temp sensor located on a 2006 hyundai sonata
crankshaft? what crankshaft? I think thats the engine connector you're pulling
it is on the tranny.
A person should know the location of the sensors in a vehicle. The IAT sensor is located on the air intake housing of this vehicle.Ê
www.hyundaiusa.com. Pls see the answer to the question posted Sep 30, 2006 "Where can you get free technical information for Hyundai cars?" for details.
The fan will not turn on till your vehicle is at operating temperature. Check it again when the engine is hot.
IAT - Intake(or incomming) air temperature sensor. It will be located along the air intake tube. It is usually either on the airbox or right after. Before you get to the mass airflow sensor. It usually just is held in the tube by a grommet. Undo the connector and pull it out.
There is an output speed sensor located in the lower (looking into the engine bay) right hand side mounted to the transaxle in the front portion on the top just underneath the air cleaner.
Connector "J", Pin# 04 is the wire for the speed sensor on the BCM(Brain Control Module). I only know this from downloading the schematic from hyundai's web site. I needed this information when I installed my GPS system. Hope this helps you.
its located inside the transmission. need to drain fluid, remove pan.
The Engine coolant temperature sensor is installed in a coolant passage which is located at the front left cornerof the cylinder head.