answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where is the orifice tube located on a 1999 oldsmobile 3.5 liter intrigue ac system?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you bypass passlock system in Oldsmobile intrigue?

how do you bypass passlock system


Where is the tensioner located on a 1998 Oldsmobile Intrigue?

Itd in the top middle towards the back in that whole system of pulleys its the one that take a 5/8 wratchet


Where is the orifice tube located on a 1999 Oldsmobile Delta 88?

A '99 Olds Delta 88 doesn't use an orifice tube system for the air conditioning it uses a thermal expansion valve. The location is under the passenger side dash in the heater/evaporator box. Unfortunately, you have to remove the dash to replace it as well as discharge the a/c system.


Why does the radio not turn off on a 2000 Oldsmobile intrigue?

Button broken? Original Delco stereos notorious for unreliability. I put a Sony system in my Intrigue when the Delco cassette player crapped out a few years ago.


Where is the orifice tube located on a 1992 Beretta GT 6-cyclinder engine?

What orifice tube? An orifice tube is part of the AC system pull off the lines going into the accumulator. You'll see it. DoratheExplorer


Is it possible that my security system causes my 2001 Oldsmobile intrigue to not start?

It IS possible. Tell us more-- does it crank over? Have you checked anything else?


Where is the expansion valve orifice tube on a 2.5L 1998 ford ranger AC system Thanks.?

There is no expansion valve. There is an orifice tue. It is located in the inlet tube of the evaporator core.


Where is the PCV valve located on a 1997 Jeep Cherokee 4.0?

It does not have a pcv valve. The system uses a fixed orifice in the rear elbow on the valve cover.It does not have a pcv valve. The system uses a fixed orifice in the rear elbow on the valve cover.


What is a 'sending unit' in relation to the coolant system in an 2000 Oldsmobile Intrigue and where is it located?

A sending unit is an electrical sensor that senses heat and sends a signal to the heat light on the dash when the engine is overheating. It is usually located on the cylinder head, usually close to the thermostat. It is about 3/4" or 1" in diameter and has a wire connected to the tip.


How do you bleed air out of the cooling system of a 2001 Oldsmobile Intrigue 3.5 liter engine?

The 2001 General Motors (Oldsmobile Division) Intrigue came equipped with the 3.5L engine and 4-speed automatic transmission FWD. One method of purging air from the cooling system after repairs and flushing it involves refilling it, and running the motor and heater, and leaving the radiator pressure cap off to 'burp' off the air trapped inside.


Had coolant reservoir replaced 2 days ago gauge is reading hot and then it will go back down to normal but its not overheating 2000 Oldsmobile Intrigue?

Air bubbles remaining in the system


Where is the expansion valve located on a 1998 dodge ram 5.2 L?

The ac system on a Ram doesn't use an expansion valve. It uses a fixed orifice system.