Toyota Sienna
Heating AC and Engine Cooling
Oxygen Sensors

Where is the oxygen sensor code P1155 located in Toyota mini van sienna?

345

Top Answer
User Avatar
Wiki User
Answered
2009-09-11 21:12:36
2009-09-11 21:12:36

Where is the oxygen sensor code p1155 located in Toyota mini van sienna?

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


its is located downstream on the backside exhaust manifold


bank 1 sensor 1 2002 on toyots sienna



If the oxygen sensor fits the catalytic coverter and female vehicle port yes


2002 toyota sienna electroni coil located


i have a 1999 Toyota seinna v6 and i will know where can i find the vehicle speed sensor.


Bank 2 is the sensor opposite from the number one cylinder, and on your vehicle is the front of the engine. Sensor 1 is the first oxygen sensor you come to from the engine in the exhaust pipe.


where is the classis location for toyota sienna


can you safely drive a 2000 camery with bad sensors


Bank 2 sensor 1 is the O2 sensor in the exhaust manifold closest to the firewall.Cut and paste the link below for a detailed fix with pics of the O2 sensor repair."http://polifrogblog.blogspot.com/2009/11/sienna-o2-sensor-change.html"


The tank that is located under the battery on a 2004 Toyota Sienna is a windshield washer fluid tank. Toyota put this tank in this position on the 2004 to 2010 models of the Sienna.


On a 2003 Toyota Sienna, the fuel filter is located in the gas tank. Toyota started putting it there either in 2001 or 2002.


The mass airflow sensor is located on top of the airbox (air filter housing). It has a plug with maybe 6 wires in it and is held in place with 2 Phillips head screws.


i have check engine light on code po171 system to lean i changed o2 sensor check engine light came back soon after, i heard that it could be fuel air ratio sensor,where is it located on 6cyl Toyota sienna, do you have any input thanks tony


The owners manual for a 2004 Toyota Sienna is located in the glove compartment. Alternative, they can be acquired directly from Toyota's website.


Where's the PCV valve located on a 2004 Toyota Sienna van




Sienna's have two knock sensors located in the valley underneath the intake manifold. Replacement is a three hour job.


its not a sensor you timing belt jumped a tooth on the camshaft sprocket on the rear of the motor...the Bank 1 camshaft...which is the one that sucks to get to


i star my Toyota sienna van and hear some noise when i turn off it the estarter still egage, wha is wrong?


i think behind the glove compartment


The fuses for 2000 Toyota Sienna is located in the engine compartment. The fuses are labeled as slot 12 and 13 and are rated at 15 amps.


The fuse box on a 2004 Toyota Sienna is located between the hood release and the steering column. It can readily be accessed by the driver from the floor board.


The 2001 Toyota Sienna OBD 2 port is on lower edge of dash; mounted on a bracket above accelerator pedal



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.