on the header
It is on the exhaust manifold. If you look down at your exhaust manifold there should be one plug sticking out of it. That's the O2 sensor.
The oxygen sensor is connected by a wiring harness. The wiring harness contains the signal wire. The signal wire goes to the system computer.
inside the distributor inside the distributor
There is 2 o2 sensors on 96 integra. 1 is after the headder and the 2nd one is at the end of the cat
The speed sensor on a 1989 Acura Integra is located on the transmission. It is a small unit with a two-wire clip which connects to the main engine harness of the vehicle.
it is located on the firewall side of the engine to the left of the oil filter
The IAT sensor, or intake air temperature sensor, is located on the tubing the of intake on a 1991 Acura Integra. This sensor reports the temperature of air coming into the engine directly to the ECU.
where is the flasher relay located 94 acura integra
The fan switch on a 1995 Acura Integra is located on the dashboard. It is a part of the temperature control system.
The IAT is located on the intake manifold right behind the Fuel Rail
where is the ignition module located ina 2000 integra acura
The sensor is located on the intake manifold or air plenum. It is removed and installed in straightforward fashion; disconnect the wiring connector and remove the mounting screws. Remove the sensor.