Under the car on the front exhaust silencer box.
its located just before the catalyst. Unlplug it then using an oxygen sensor socket carefully undo it. it will be very very tight due to the temperatures it experiences, be careful incase you shear it off!
Lambda is o2 sensor in exhaust pipe.
The crankshaft sensor Renault Clio is located on the bottom of the engine, near the oil filter. It is connected to the vehicle's computer and constantly provides information about the position of the crankshaft.
There are two oxygen sensor for Mitsubishi Outlander. Front Oxygen Sensor and Rear Oxygen Sensor
Inlet air temperature
If the vehicle was built with an oxygen sensor, you will need an oxygen sensor.
My clio wouldn't spark the other day. Turned out to be the crankshaft sensor. Apparently a common fault on clios.
If it's a Mk2 Clio then the speedo is electronic - Mk1 Clios had cable driven speedos.
It's integrated into the oxygen sensor. Buy a new oxygen sensor and you get a free oxygen sensor heater.
Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.
Remove the vacuum hose from the oxygen sensor. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.
To replace the oxygen sensor disconnect the oxygen sensor electrical connector. Use an oxygen sensor socket to remove the sensor. spray the sensor with penetration oil if it is difficult to loosen. install in reverse.