0
Where is the porcelin ignition ballist resistor for 1986 dodge half ton?
Wiki User
∙ 16y ago
ballast resistor should be on the firewall under the hood. just follow the wires from the coil and you will find it
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What causes it to not get fire to the ignition coil when it gets hot on 1988 dodge d100 v6 3.9?
Hey; Check the ballist resistor, and the voltage regulator. Unidrv
Where is the ignition ballast resistor on a 1988 dodge Dakota 3.9?
A 1998 Dakota does not have a ballast resistor.
Where is the Location of ignition resistor on a Dodge van?
Look behind master cylinder, it will be white.
Where is ballast resistor on Dodge Grand Caravan sport 2002?
It does not have a ballast resistor, those were used for ignition systems 30+ years ago. It does have a blower motor resistor that is located behind the glove box.It does not have a ballast resistor, those were used for ignition systems 30+ years ago. It does have a blower motor resistor that is located behind the glove box.
Location of ballast resistor for 94 Dodge Ram 1500?
A 1994 Dodge Ram does not have a ballast resistor.
How do you replace the ignition timing on a 1987 Dodge Ram 350?
the ignition timing does not get replaced on 87 dodge.
98 dodge caravan how to replace front blower resistor?
The front blower resistor on a 98 Dodge Caravan is replaced by removing the cover and disconnecting the wiring harness. The resistor can then be pulled and a new one put in its place.
Does a 1997 Dodge van 1500 have a ballast resistor?
No.
Where is the ballast resistor located on a 1986 dodge d100?
The ballast resistor is located on the left inner fender.
Where is ignition switch of 2000 dodge ram 2500?
A retaining clip holds the ignition switch in place on the back of the ignition cylinder on your 2000 Dodge Ram.
Where is the resistor located on a 1986 Dodge D100?
The ballast resistor is located either on the firewall or on the left inner fender.
How do you stop a 1988 Dodge 5.2L Ram charger with SMEC TBI from stalling everytime its ignition key's turned to RUN even though it always starts OK?
ballest resistor is open get a new one.
