It depends on the year and the engine. It has been on the front or back, top or bottom.
Top of engine, far passenger side.
most likely low power steering fluid level or the level was low and took out the pump.
Left side of motor at the top - rear - close to the firewall. Not easy to access.
You can not. The pump is need for proper operation of the steering gear.
The power steering pressure switch, on a 1993 Chrysler New Yorker, is located below the power steering pump. The pressure switch is attached to the power steering reservoir mounting bracket.
In the power steering pump located on the front right side of the engine. It will have a pulley on it
sounds like a bad power steering pump
A power steering pumps as much as the power steering pump can pump.
Remove the power steering pump hose. Remove the power steering pump belt. Remove the power steering pump retaining bolts. The power steering pump will come off.
Usually if this pump makes noises it means that it could be low on fluid or the bearings are worn and needs to be replaced.
Secure the power steering pump with the retaining bolts. Attach the power steering hose to the power steering pump. Put the belt on to the power steering pump. Fill the power steering system with fluid.
Check for a low power steering fluid level. Leaky power steering pumps are common. When power steering fluid level gets low, air bubbles form in the fluid. As the bubbles pass through the pump, the pump smashes the bubbles which results in a vibration. The pump doesn't like the vibration, so it gets sad and moans like a whiny little biotsh.