At the bottom of the radiator, you can see it from under the truck.
how do I bleed the clutch system in a 2004 ford ranger
It should be on the bell housing above the hydrolic hose, mine had a rubber cap covering it.
You will not believe this... It is right in front of the battery, between the Radiator and the headlight. It has one screw that holds it on. Take the battery out, remove the screw and then pull it our... take the harness off after you get it out.
what type of radiator fluid does a 2000 ford ranger take?
On a 2000 Ford Ranger : With the engine cold the radiator should be filled to the seat for the radiator cap and the engine coolant reservoir should be filled to the cold mark
driverside @ bottom of radiator . there will be a screw that has a (+)cut out in the middle . get a big flathead screw driver and turn
ANSWER: On the lower left side of the Radiator (passenger side).
If there are no schrader valves to bleed the system, remove the radiator cap, make sure the radiator is full of coolant, turn the heater controls to HOT, start the engine, watch for air bubbles escaping, keep the radiator full, and when you see no more air bubbles escaping, replace the cap. The system is now bled.
no
The air conditioning condensor
Does not have one. Just a reservoir.
looking at the motor, its on the right side of the radiator at the bottom