Radiators
Chevy Blazer
Chevy Blazer S-10

Where is the radiator drain plug on a 2000 Chevy Blazer?

353637

Top Answer
User Avatar
Wiki User
Answered
2010-07-30 17:06:01
2010-07-30 17:06:01

I have a 1999 Blazer and I was looking for the radiator drain plug as well yesterday. mine appears to be broken but it is located on the passenger side of the radiator near the bottom edgeon the engine side you might have a small black rubber hose coming of of the area of the drain I think this is supposed to make collection of the coolant easier. The drain is plastic and should look kind of like a wing nut. You also get the best access to it from inside the wheel well by moving out of your way a rubber skirt. Its still not easy there is not much room. I have read others have just removed the lower hose to drain the system. I know that makes a real mess.

1. Turn wheels all the way to the right.

2. Lift rubber flap inside passenger side (right side) wheel well to access white plastic drain cock

3. Place 1/4" drive rachet into end of drain cock and rotate 90 degrees (1/4 turn) counter clockwise

4. Remove rachet and pull white plastic drain cock outwards (towards firewall) to release coolant

Good Luck.

012
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


AnswerLook at the bottom or rear of radiatorit is on the front right of radiator!!on bottom.


well its prob the same as the 95-96-97 etc......remove the air cleaner hardware, and the windshield washer bottle... after that, you can see the drain cock...lower drivers side


It is just beneath the lower radiator hose.


There is a drain on the lower right of the rad. If you can't get to it, pull the lower hose.


I think I had the same problem on my 2000 and decided to just take off the lower radiator hose to drain it.


The radiator drain plug on a 2000 Chevy Venture is removed by slowly turning it in a counter-clockwise direction. Care must be taken when re-installing the plug to prevent cross threading.



How do you set the timing on a 2000 Chevy blazer (V6)


Follow the top radiator hose down to the water outlet on the engine. The stat is in there.


An alternator from a 2000 Chevy blazer will fit a 2002 S10 blazer with a little fabrication.


Assuming you mean the engine oil drain plug, a 15mm wrench should do the job.


front splash shield has to come off! then you can see the drain on the right bottom of radiator looking at it from front of car. you can use a Allen wrench to loosen the drain plug.


It is located on the driver's side of the radiator in the lower corner. It is plastic and green in color. Mike


the radiator drain plug is on the bottom right facing car from front. you may have to remove the sheild to get at it. my 2000 malibu uses a allen wrench to loosen the drain plug for the radiator. good-day !


The 2000 Cadillac Escalade radiator drain plug can be found on the right hand side of the radiator. The drain plug will be at the bottom corner of the radiator.


Yes, a 2000 GMC Jimmy hood is compatible to a 2000 Chevy Blazer. This is only on the S10 Blazer though.


how many gallons of antifreeze in a 2003 blazer radiator with a/c


Will a 2000 blazer transmission fit a 1998 s 10 chevy 4x4 truck


how do you replace seatbelt retractor on a 2000 chevy blazer


The 2000 Chevy Trail Blazer doesn't have a timing belt.


If your referring to the drain plug, it's on the driver side of the radiator on the very bottom facing the front of the car. CCW opens the drain valve and CW closes it.


there should be a bleed valve towards the bottom of the rad. It will look like a " T : .



NO it will not. They are complete DIFFERENT designs. Will NOT interchange.


Usually on the coolant outlet just before the upper radiator hose.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.