on the 2006 models of the Ford Fusion. the radio antenna is embedded in the back glass with the rear defrosters. It's important to know that when installing aftermarket radio you should connect pin 5 on the radio harness to a switched 12v source. If not done this will cause problems with radio reception! pin 5 is the antenna's booster power wire and was originally powered off of the stock radio but the aftermarket radios do no supply this power source. I reccommend using a relay and the remote antenna wire and 12v constant wires off the new radio harness to make this connection! this will allow the the remote wire to switch the relay on and off when the radio powers on, and connect the the tapped 12v constant wire to the antenna booster power! thats how i would do it!
where is the throttle position sensor located on the 06 ford fusion
Begin by removing the radio retaining cover. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness and the antenna cable from the back of the radio.
Inside the passengers side, rear side window on the Expedition.
Remove the radio retaining cover. Remove the radio retaining bolts. Remove the wiring harness and the cable antenna from the back of the radio. Reverse the process to install the new radio.
inside evaporator case
Yes you can buy a stubby antenna off E BAY.
It's surface-mount LEDs. If you know how to solder, they're green PLCC2 LEDs.
The antenna is in the middle of the roll bar by the sound bar. It faces up and the wire will run down the roll bar and under the carpet to the dash and then to the radio. In 07 the antenna is in the middle of the dash and under the coin area. This doesn't seem to work as ell as the mount on the top of the center roll bar in the 06 models
The 2006 Ford Fusion has 16 valves.
where is the fuse located for the 2006 Toyota corolla
Up near the steering wheel mechanism behind the dash.
The 2006 Ford Fusion has a 5-speed manual.