on the bottom side of the throttle body.
Locate heater control valve in a 2001 Honda civic
The PCV valve on my 2005 Pilot is bolted horizontally into the side of the valve cover right next to where the oil dipstick is.
The evap control valve is on the cannister
Idle air control valve diagram
The 2006 Honda Pilot has a timing belt. The engine is a J35 series SOHC 24-Valve 3.5L V6 motor with cylinder deactivation (2WD models only).
The Honda B18b1 engine found the many Acura Integras use an idle control valve. Its idle control valve is placed on the intake manifold and uses a flat valve which can be screwed in and out to lower or raise the idle.
It is the thin copper line coming out of the bottom of the control valve and running to the pilot light. Should follow the tube coming out of the bottom of the control valve that supplies gas to the pilot light.
1990 Honda accord ex how would you know if idle air control valve is bad?
where can i get a pilot valve for gas air compressor
The thermocouple is the small tube that runs between the pilot light and the control valve. The valve end unscrews and the pilot light end in held in place with a spring clip that the tip pushes through. Unscrew the valve end and work the pilot end out by twisting it and pulling it out of the clip. Install a new one making sure the end is in the pilot flame and light the heater. No gas will come out when you take it loose from the control valve.
The idle air control valve controls the neutral idle of the 2001 Honda Accord. A faulty idle control valve leads to an erratic idle. To replace it first locate the valve on the intake manifold. Unplug the unit and remove the three bolts holding it to the manifold.
Idle on a 1985 Honda Civic is adjusted through a idle air control valve. This valve is located near the intake. Adjust the valve by either loosen or tightening it.