0
Where is the sensor for the engine coolant on a 1991 Ford Probe lx?
Wiki User
∙ 10y ago
The sensor for the engine coolant on a 1991 Ford Probe LX is inside of the coolant tank. There is a lever, and when the fluid gets below this lever, it signals to be checked. It should be refilled.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Where is the coolant temp sensor on a 1991 ford 4.9?
The coolant gauge temp sensor is a one wire sensor located on the right rear of the engine block.
How can you check the Engine Coolant Temperature sensor on my 91 Honda Prelude SI 2.1L?
How can I check the ENGINE COOLANT TEMPERATURE (ECT) sensor on my 1991 HONDA PRELUDE SI 2.1L
Where is the coolant temperator sensor 1991 berretta?
On the engine block, near the thermostat housing.
Where is the temperature sending unit on a E150 1991 351CI engine?
Which temperature sensor? There is an air-fuel charge sensor, and a coolant temp sensor.
White smoke comes out of the exhaust of your 1991 ford probe gt?
engine coolant is getting into an engine cylinder , from a bad head gasket , warped or cracked head
How do you diagnose a coolant temperature sensor and oxygen sensor on a 1991 Hyundai Excel with 1.5L EFI Mitsubishi engine?
The best way is to find someone with a scanner that tells you what every sensor is doing.
Engine codes 22 34 45 in 1991 Chevy Camaro replaced map sensor tps an o2 sensor coolant temp sensor what could be the problem?
intake manifold vaccum leak
Where is the coolant sensor on the radiator of a 1991 Cadillac deville?
By the thermostat
Where is the coolant temperature sensor located on a 1991 Pontiac Sunbird with a 2.0 liter engine?
on the right side of the block just above the trany The sensor is located just above the manfol.
What is code 15 on a 1991 Chevy s-10?
problem with the coolant sensor check the connection on the sensor reset your OBD I code if that don't work replace the coolant sensor
Where is the Coolant temperature sensor on a 1991 Chevy truck?
sould be on the manifold
How do you replace the engine coolant on a 1991 Honda Civic?
The engine coolant on a 1991 Honda Civic is replaced by turning the drain petcock and releasing the coolant. The filler cap is then removed and coolant added until the system is full again.
