on the top of the snow blower you'l see the choke knob. just pop it off with a flat head screw driver. next there are two screws holding the the plastic cover on top of the blower, unscrew those and pop off the plastic piece. under that you'll see the spark plug!.... hope this was helpful. good luck!
what is the spark plug setting for 7hp self prepelled troy bilt mower
.030 (0.76 mm) gap. Use a Tecumseh resistor plug.
Rdz19h
.025 according to the manual.
RDJ7Y Champion
0.020
BILT means Ballarpur Industries Limited. It is a big writing and printing paper producer in India. BILT owns stakes in paper and pulp production at Sabah Forest Industries which is located in Sabah, Malaysia.
Usually on the bottom of the seat.
Hi, That is an MTD part number. Look at the engine decals or model number ID tag and get the plug based on that.
Start by checking your spark if you don't have spark check the spark plug. If the spark plug is ok then check your flywheel - It may have rust on it. Clean it up and clean up your coil and see if you have spark. If you still don't have spark change your coil. If it has spark and no fuel - clean your carb.
The owners manual states that the proper plug gap is .020"
The population of De Bilt is 42,052.