The only speed sensor on the engine is inside the distributor.
Rear of engine, screwed into exhaust manifold.
It is screwed into the exhaust manifold on the back of the engine.
The sensor in the distributor is the crankshaft position sensor.
It is screwed into the exhaust manifold on the rear of the engine.
It accessable from below, under the car or from above to the rear of the engine head. Get a Haynes or Chilton manual for you make.
It is a two wire sensor, very near where the upper radiator hose attaches to the engine.
In the exhaust pipe before the catalytic converter, which is right behind the engine
The Chrysler Sebring knock sensor is located in the engine valve or cylinder located at the back of the motor. This part is in this position next to the engine valve so the sensor can feel the vibration of the engine.
exhaust manifold
Answeron the rear of the engine, towards the transThe cam sensor is in the distributor.
The engine computer uses the coolant temperature sensor that is located close to where the upper radiator hose attaches to the engine to decide when to actuate the fan.The engine computer uses the coolant temperature sensor that is located close to where the upper radiator hose attaches to the engine to decide when to actuate the fan.
Two wire sensor just behind where the upper radiator hose attaches to the engine.Two wire sensor just behind where the upper radiator hose attaches to the engine.