There are two speed sensors, an input and output. They are located on the transmission. If the problem is the speedometer not working it is the output sensor located on the driver side of the rear of the transmission.
The transmission speed sensors are located on the driver side of the transmission case. Those are also where the speedometer signal comes from. The abs sensors (if equipped) are located at each wheel bearing.
The transmission speed sensors are located on the driver side of the transmission case. Those are also where the speedometer signal comes from. The abs sensors (if equipped) are located at each wheel bearing.
The transmission computer uses it to know the rotating speed of the input shaft.
this issue is usually caused by the output speed sensor. that is a common problem with all Chrysler products. it is located on the transmission
The only speed sensor on the engine is inside the distributor.
The output speed sensor is the two wire sensor on the front, far driver side of the transmission.
The input and output speed sensors are located on the front of the trans. They have two wires and the input sensor is closer to the engine.
The vehicle speed signal comes from the transmission output speed sensor, driver side of the transmission. It is the rear most two wire sensor.
It is a two wire sensor to the rear of the driver side of the transmission case.It is a two wire sensor to the rear of the driver side of the transmission case.
There are two on the transmission and one at each wheel bearing.
There is no such part as an idle sensor. Idle speed is a computer output that involves dozens of inputs.
They are on the driver side of the transmission.