0
Where is the speedometer sensor located in a 1990 Chevy truck 4x4?
Wiki User
∙ 13y ago
It has 1 small bolt holding it in the drivers side of the transmission tail shaft and it has an electric connector plugged into it.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Position of crank sensor on 95 Chevy truck?
Where is the crankshaft sensor located on a Chevy 1500 sil. turbo diesel truck?
Where is cam sensor located on 1989 Chevy truck?
That year did not have a cam sensor.
Location of crankshaft sensor for a 1992 chevy 1500 truck 4.3 engine?
The crankshaft sensor is located in the engine on a Chevy 1500 truck. This is under the hood.
Does a 1992 Toyota 4wd truck have a speedometer cable or sensor?
my 92 yota has a sensor. the plug is located on the passenger side of the trans.
Where is bank 1 sensor on chevy truck located?
Driver side.
Where is the speed sensor located on a 2005 dodge diesel truck?
The speedometer signal comes form the abs sensor on top of the rear axle.
Where is the vehicle speed sensor located on a 1994 Chevy silverado truck?
The vehicle speed sensor, on your 1994 Chevrolet Silverado pickup truck, is located on the back of the transmission. The speed sensor is labeled as such.
Where is the fuel level sensor located on a 1997 Chevy s10 truck?
the fuel level sensor is located in the fuel tank with the fuel pump
Where are the sensor for 1993 Chevy truck transmission?
The sensors are located on the transfercase for your cluster panel
Speedometer stopped working on 2003 Chevy truck?
If both the speedometer and odometer stopped working it is probably the speed sensor in the transmission gone bad. If only the speedometer quit you may have to replace the dash cluster with a reconditioned unit.
Why Chevy truck wont go into third gear?
IF the speedometer is not working it is because the computer is note getting a signal from the trans. and will not tell it to shift. Try replacing the speedometer the sensor in the tail shaft of the trans.
Where is the NOx sensor located on a 1987 Chevy truck?
the oxygen sensor is in the exhaust manifolds, there should be one for each side
