Want this question answered?
3 just on top of the engine,u can see black cap with screw and wire,other 3 under the intake.
Google the model car and the wire diagram follow cd player diagram and fix wires together
There are two MAP Sensors on the Mitsubishi Montero Limited. They are both located on the left side of the engine about six inches apart. Look for a plug with a wire attached that resembles a spark plug wire boot.
The pressure switch is located on the back of the power steering pump which is on the passenger side of the car at the rear of the engine. You can reach it from top or bottom but I found, to take it out it is easier to reach from under the car. It is the only part of the power steering pump that has a wire going to it.
it is usually located on a metal bracket,close to the coil.it has a 3 wire plug attached to it.
If it has a 3.0 L engine, the module is located to the left of the coils bolted to the intake on a shiny silver plate. It has a a three wire plug and a six wire plug in the top of it.
On the 1.8 engine, there are two: one located on the exhaust manifold - it has a wire/connector coming from it. one located just behind the catalytic converter beneath the car
On the top of the tranny. There will be a black wire sticked in there. It`s on there loose, so you can just pull it out, or stick it in
It attaches to VSS on tranny by where it meets driveshaft.
Refer to your service and user manual on how to change an alternator ground wire on a 1994 Mitsubishi 3000 GT.
The red wire is the hot wire. The black wire is the ground wire. The green wire is the speaker wire. The white wire is the auxiliary wire.
The ground wire is a black. The positive wire is red. The speaker wires are yellow and green. The auxiliary wire is white.