do you have 2000 mazda 626 dash board?
I have a 94 Mazda 626, and i had this issue the starter was bad car would not turn over to start it just died on my while driving came to a stop light and bam died. I change the starter and it started right up now it works every time on the first try.
check your links on the transmission cable.
There is a wire harness. The bulbs tend to go out.
No you cannot swap a 94 into a 96 626 and vice versa. But you can use a 96 Ford Probe transmission in a 94 626. Check www.car-part.com for a list of transmissionsin your area. The listing will show alternative vehicles that the same tranny came in. I use it all the time when hunting compatible parts.
yes it fits, they even fit in a ford probe there all the same engine, I currently have a 94 Mazda 626 with an 95 mx6 engine, 4 banger, but the same goes for v6,
Most of them, 94-98 The 93:s second gen have a different wiring than the 94-98 when it concerns the engine electrics but mechanically thay are more or less the same. My 94 SE is running with the disty from a Mazda 626, the driveshafts from an Ford Probe GT V6 - 97, the brake discs and brake pads for a Mazda 626. The engine is more or less equal to the Mazda 626 egine, the valve cover differs. The chassie is more or less mechanically a 626. The Probe is an MX-6 with different valve cover and bumpers and the MX-6 is the sportier model of an 626.
i have a mazda 1994 626 v6 24 valve car and i think the timing belt just broke where are all the timing marks crank shaft and cams?
AnswerRight under the back intake manifold
Check in the fuse box under the hood over the left front tire. That's where it is on my 94.
The starter on a 94 Isuzu Trooper is located on the bottom, passenger side of the vehicle. It is found at the rear of the engine, at the flywheel.
You did not specify which O2 sensor it is. Is it sensor 1 bank 1, sensor 2 bank 2, sensor 2 bank 1, or sensor 1 bank 2. There are four O2 sensors on a mazda 626
i was told by a technician that you turn the cilynder itself, and it would go back in... i tried this myself, and can still not get it to go in.. aynone heard about this?
My Mazda is a 94. There is a black switch near the hinge on the driver's door about 6" from the floor board in front of the fuse box. The down position turns it off.
The 1994 Toyota pickup truck starter mounting bolts can be found on the head of the starter. There will be three mounting bolts.
The size of front speakers on a 94 Mazda 121 are 130mm.
you have to kneel on the back seat and remove the cover from the rear deck.the bulb socket is turned counterclockwise and the bulb can be replaced.
need to know what wire go were for a 94 Mazda protege MAF sensor
The fuse box should be in the engine compartment. Lift the cover off of the fuse box. Turn the cover over & there should be a diagram on the underside of the cover.
yes the motor will fit becuz 2nd generation probes are years 93-97Answeryou can put any of the following in your probe. 93 to 97 forb probe, 93 to 94 Mazda 626 and 93 to 94 Mazda m6. all thouse motors will work in your car.
The best i have found is an owners manual. http://jdmfsm.info/Auto/Japan/Mazda/323/323F%20Mazda%20(89-94).pdf
noAnswerno the only years that will work are 93 to 94 ford probe, 93 to 94 Mazda 626, and 93 to 94 Mazda M6 and if its a (CD4E) Transmission good luck you will need it! Answerthe tranny form a 93-95 should work i swaped my auto out to a 5 speed from a 95 and my car is a 93 works fine few extra parts left over