answersLogoWhite

0


Best Answer
Copy

it will be poking out of the transmission bellhousing where it attaches to the engine. It is on the passanger side (Right side) of the engine, right below the intake manifold. It has the battery positive cable and a smaller wire from the ignition attached to it and is held in place by two 13-MM headed bolts. Remember to remove the negative battery cable before going anywhere near the starter.

User Avatar

Wiki User

โˆ™ 2006-02-13 15:12:04
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Where is the starter located on 1991 Geo Tracker?
Write your answer...
Submit

Related Questions

Where is the fuel filter located on a 1991 Geo Tracker?

THE FUEL FILTER FOR A 91 GEO TRACKER IS LOCATED UNDER THE CAR NEXT TO THE FRAME BY THE REAR AXLE NEAR THE FUEL TANK.


Where is the starter relay on a 1997 Geo Tracker?

How cha~ge oil tra~smisio~ of a geo tracker 95


Will a 1993 Geo Storm motor fit a 1991 Geo Tracker?

Yes.


Where is the starter located 1995 Geo Tracker?

on the passenger side of the engine. you can see it from the top and it has a rubber boot on the forward end.


Where is the starter on a 93 Geo Tracker?

Standing in front of the vehicle the starter is located on the left side mid way down under the fuel injection system.


Willa 1993 Geo Metro motor fit a 1991 Geo Tracker?

www.mem.com


Where is a sterter located on a 1996 Geo Tracker?

the starter is located on top of the transimission. the top bolt is extremely hard to get to and the bottom bolt can be reached from the underside of the vehicle


Will parts from 1987-1994 Geo Trackers work on a 1991 Geo Tracker?

yes,all tracker use the same parts


Where is the hood release on a 1991 Geo Tracker?

In the glove compt


What is the gross vehicle weight of a 1991 Geo Tracker?

about 1,300


Is the fuel PUMP in a 1991 Geo Tracker in the gas tank?

Yes


Can you replace a crankshaft in a 1991 Geo Tracker without pulling engine?

No


Gas tank size for 1991 Geo Tracker?

11 gallons


Where is the crank angel scencer at in a 1991 Geo Tracker?

Inside the distributor


Will the computer from a 1994 Geo Tracker work on a 1991 Geo Tracker?

Yes if it is the same trany. Auto will work in a manual but not the other way around. On_mitch


How do you locate the starter solenoid on a 1997 Geo Tracker?

Follow the pos battery cable.


What is the firing order for a 1991 Geo Tracker?

1-4-3-2


How do you change the starter on a 1991 Geo Prism?

Same answer as: "How do you replace a starter on a 92 Geo Prism LSI or GSI?" at this same site.


Where are the fuel filters located on a 1991 Geo Tracker?

The fuel filter is always located on the fuel intake line going into your carberator. It is usually accessable from the left side of your engine.


Where is your IAT sensor on your 1990 Geo Tracker?

The 1990 Geo Tracker IAT sensor is located on the top of the transmission. The IAT sensor will be near the back of the transmission.


How do you replace the starter in a 1991 Geo Tracker?

disconnect negative(-) battery cable, disconect the two wires at the back of the starter. unbolt starter and remover, then to install do same ateps in reverse. o and the atarter is under the intake manafold were the motor and trany meet.


Where is the hood release located on a 1996 Geo Tracker?

in the glove box


Where is the horn located on the 1996 Geo Tracker?

between the grill and the rad


Where is the starter relay on a 1992 Geo Tracker?

inside the fuse/relay center probably under the hood


Where is the speed sensor located in a 1996 Geo Tracker?

The speed sensor for a 1996 Geo Tracker is located on the transmission housing. The speed sensor is important , it keeps track of the tires and delivers the figures to the main system