0
Four cylinder, it is on the rear of the engine below the exhaust manifold.
Six cylinder, it is on the front of the engine, behind the motor mount bracket.
Four cylinder, it is on the rear of the engine below the exhaust manifold.
Six cylinder, it is on the front of the engine, behind the motor mount bracket.
Wiki User
∙ 10y ago
Wiki User
∙ 10y agoFour cylinder, it is on the rear of the engine below the exhaust manifold.
Six cylinder, it is on the front of the engine, behind the motor mount bracket.
Add your answer:
Earn +20 pts
Where is the carburetor located on a 1993 Chrysler lebaron?
A 1993 Chrysler LeBaron is fuel injected and does not have a carburetor.A 1993 Chrysler LeBaron is fuel injected and does not have a carburetor.
Where is the starter located on a 1993 Chrysler lebaron 6-cylinder engine?
It is behind the engine mount on the front of the block.
Where is the solenoid located under the hood of a 1993 Chrysler Lebaron as it will not start we have replaced the battery and starter and could it need a new solenoid and where is that located?
may be on top of the starter and replaced with same. Follow the + battery cable it will connect to the solenoid
Where are the engine mounts located at on a 1993 Chrysler LeBaron gtc?
Right, left, and front.
Where is the thermostat located on a 1993 Chrysler LeBaron?
It is located under the housing where the upper radiator hose attaches to the engine.
Where is the timing belt located on a Chrysler Lebaron 1993?
It is under the plastic covers on the passenger side of the engine.
Where is the crankshaft sensor located on a 1993 Chrysler lebaron le?
The sensor in the distributor is the crankshaft position sensor.
How do you remove the trunk lock cylinder from a 1993 lebaron GTC convertible?
Show removel of trunk lock 1993 chrysler lebaron
Is there a hand crank for the convertible top on a 1993 Chrysler LeBaron?
No.
Did they make a 1993 Chrysler LeBaron without power steering?
No
What type of antifreeze do you use in a 1993 Chrysler LeBaron?
Green
How do you tell what starter a 3.0 liter 1993 Chrysler lebaron takes?
The starter is either a Bosch or Nippondenso.. you'll have to pull it out and see.. Theres 3 bolts holding the starter into the bell housing.. undo all wires and remove the bolts..
