The starter can be seen under the intake piping. Remove the pipe from the throttle body, and then you'll see the starter. You should be able to trace the negative battery cable to it. It has three bolts and can require much finesse to remove once unbolted.
The starter on a 2001 Ford Focus ZX3 is located in the undercarriage on the driver's side of the motor. This part is one of the hardest to change on the Ford Focus because it is so hidden by other parts of the motor.
on the passenger side underneath where the motor and transmission meet
engine compartment
AND USUALLY CONNECTED TO THE ENGINE.
dsdfsd how to change a fuel pump on a 1999 ford escort zx2
Auto parts store, dealership
You should be able to, the only differerence is a zx2 is a dual cam engine, both are 2.0, so the basics are there the same block, which means same bolt pattern.
As per the amsoil website, 4.6 quarts!
Begin by removing the positive cable from your battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new Ford starter.
The solenoid is on the starter.
www.teamzx2.com
The starter is located between the engine and the firewall towards the bottom. There are 3 bolts that hold it in place. zx2 2002 model.
should be under the intake on the back end of your engine
If I'm not mistaken I believe the starter is under the intake on the back of the engine between the block and the firewall.
Bad battery, starter, cables or switch.
The starter on a 1999 ZX2 with the 2 liter DOHC engine is tucked up behind the intake manifold, bolted to the transmission bellhousing. Look for it at the junction of the engine block and the transmission.
The starter is located between the engine and the firewall towards the bottom. There are 3 bolts that hold it in place. zx2 2002 model.
your battery is flat Could be that your starter is dead. The clicking is the starter solenoid. That's a good thing that it is at least clicking. Replace the starter.
behind the engine right by the back of the intake manifold only 3 bolts the hold it the the block
Engeine spec ford zx2 essort 2000
look for it at the bottom of thee moter next too the main spin plate!!