Starters and Ignition Systems
Saturn (car)
Saturn S-Series

Where is the starter located on a 94 Saturn SC2 and how hard is it to replace?

798081

Top Answer
User Avatar
Wiki User
2011-09-13 11:12:25
2011-09-13 11:12:25

under hood, bottom back of motor. fairly easy.1.disconect negative battey terminal2.raise vehicle. place on jack stands for safety3.from under vehicle remove the starter brace4.remove the wire harness from brace on transaxle bellhousing5.remove the two bolts holding the starter. 6.lower slightly to gain access to the wires on the starter solenoid. disconnect electrial connectors from solenoid terminals.7.remove from engine

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

On a 98 venture the starter is located in front and just under radiator. Simple to reach and change. I learned the hard way.

User Avatar

it under the car near the oil pan 2 bolts and it hard as all to get to the top one

User Avatar

It is located on the passenger side in the back of the motor The best way to get to it is from underneath the car. It is hard to find but it there. It tucked away

User Avatar

how to replace rear struts on a 2002 saturn L 300

User Avatar

The Starter is located right under the intake manifold on the left side.. pretty hard to get to...

User Avatar

The starter is located on the passenger side of the block, kind of hard to reach and a pain to remove.

User Avatar

the starter it's self is about $100 it's not to hard to replace just under the breather at the front of the engine

User Avatar

under the passenger seat but its hard to removed it

User Avatar

Remove - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter

User Avatar

The Starter Motor Is Located Under The Intake Manifold, You Have To Remove A Bunch Of Stuff To Remove The Manifold To Get To The Starter, It Is A Small Gear Reduction Starter. Not Hard To Replace At That Point. But A Lot Of Trouble To Get To. I Recommend You Take It To A Good Garrage. Expect To Pay A Pretty High Price Also. Considering The Labor Involved. GOD BLESS

User Avatar

It is a relatively easy job to replace your speakers depending on where they are located.

User Avatar

starter may be going out, may need to replace your battery.

User Avatar

this is crazy as hell but,the starter is under the intake manifold directly in the center of the motor.so remove intake manifold and then remove and replace starter.not hard ,just time consuming.

User Avatar

You have to remove that starter through the top of the engine compartment PLEASE BE PATIENT It's not that hard.... but you get dirty because it's in a hard to reach spot. You will neeed to have a range of extentions with the wobble feature or a universal joint.

User Avatar

NO. it is not inside the engine. 2 bolts will release it from flywheel. Follow positive battert cable to starter.

User Avatar

The starter is hard to get at under the fuel lines and junk on the drivers side of the engine compartment. I had mine done by a mechanic because it was to difficult for me to get at.

User Avatar

The starter is hidden under the throttle body. Also very hard to get to, not to mention hard to see. I'd recommend having a professional do the dirty work.

User Avatar

The started on a 1996 Chevy S10 4 cylinder is located under the battery and to the right. With the right tools and time it is not hard to replace.รŠ

User Avatar

Disconnect the negative on the battery. Then jack the truck up & unbolt positive & negative wires to starter. Then unbolt starter from truck. Not hard to do at all

User Avatar

I have a 1990 pathfinder and just changed the starter 3 days ago. It was pretty simple but i had to remove the oil filter to get it out and it was still hard to get out.

User Avatar

I have a 1996 Z71 with a vortec 350. It has a new battery and starter but turns over very hard. I can get it to start with a jump but not without. What am I overlooking?

User Avatar

1. Remove the negative battery cable. 2. Remove wires on the starter. 3. Remove the two mounting bolts. They have 15mm heads. (The top bolt is hidden and hard to get to.) You may have to remove the solenoid (on top of the starter) to get to it. 4. Remove starter Replacement is the opposite of the removal.

User Avatar

The starter can be seen from under the car and is located just in front of the oil pan and the nose of it more to the drivers side of the motor (edge of the motor and transmission). It has a round motor you will see and two wires will be bolted on to it. It is not hard to change just disconnect your battery fist, remove the nuts that hold the wires on and there are two bolt that hold the starter on to the engine. One is at the bottom of the starter and the other is up the side towards the front of the car (both on the nose of the starter)

User Avatar

It's not very hard if you have done some work before. Their are two bolts holding it in one is on top of the starter and a tough to see but you can still get a socket and ratchet on it. You shouldn't have too much trouble with the repair though. Saturn Tech


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.