The starter on a Peugeot 106 is located at the back of the engine block on the right side. Very difficult to locate from above, since it is below the intake/airfilter equipment. From below it is easier. Take of the right front wheel and jack the car up or go underneath in a pit. There you will find the starter and one may see the electrcal connections to it. It is fastened with two bolts underneath (at the rear side of the starter and one on top going through the transmission block. On the diesel you need to remove the exhaust heat shield, and it will help to remove the exhaust front pipe - what a pain!
go to a garage and pay through the nose.
As long as it comes of the same type of engine out of a citroen saxo, it will fit the peugeot 106
how to remove starter motor for Peugeot 206 1.4 hdi.
how do youremove a starter moto on a peugeot 406 please
I am in South Africa and I just found out I need a new starter motor for me Peugeot 206cc. R3500 approx incl labour. WHAT! Is it this expensive in other countries?
In the space under the hood.
under the air filter
What's the question? Yes, a peugeot 106 has dashboard lights.
i dont know how to fit a stater moter!!
got fuel if so is the starter motor cranking the engine over if to that means battery ok so could be fuel injection pump or carb. spark plugs if petrol
No the Peugeot 106 is not considered vintage. This is true because the Peugeot 106 was made in the year 1991. To be a vintage car you have to be around for more the 20 years
It's mounted on the engine's base, where the gearbox conects with the engine. if you know where the clutch disk is you should see the starter motor next to it.
If it is a diesel then it is behind the radiator under the diesel filter, it is a awkward position!
Yes, as long as your wheels are 4 stud. Some peugeot 106 models are 3 stud.
Peugeot 106 cars are no longer manufactured. If you want to buy one, you must buy it second hand. However, the Peugeot 106 was originally manufactured in France. They were also manufactured in Tunisia.
Peugeot 106 workshop manual.
i have a peugeot 106 zest 3 1.5 s reg probulem with rear door not closing propely
The 106 GTI Peugeot vehicle was in production from 1996-1999 as a French vehicle. The original Peugeot vehicle was first introduced in the fall of 1991.
changing speedo cable pergeot 106