0
look at the lower rear end of the engine on the passenger side
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Factory rim width on 1993 Ford Probe gt?
ford probe gt rims are 7 inch
How can you get your starter to catch on your Ford Probe 94 Gt?
If the starter is spinning but not catching, the problem lies in the starter drive (also called bendix). You will either have to replace the starter or repair it by replacing the bendix.
Where is the block heater on a Ford Probe gt?
The ford probe gt does not have a block heater block heaters are normally on a desiel Engine
Where is the starter located on a 1994 Ford Probe GT?
Facing your engine, it is on the right side underneath the air intake filter assembly.
Will a 1994 Ford Probe Alternator fit on a 1993 Ford Probe gt?
if the 94 probe is a GT, yes. the 2.0l alternators are different from the GT the autozone part numbers for the 94 2.0L Probe is 14449 and the part number for the 94 2.5L GT is 14450
Will a sunroof from a 1995 Ford Probe GT fit into a 1994 Ford Probe SE?
Yessir, it will.
Does a Ford Probe gt have shocks or struts?
Struts
Does a Ford Probe gt have a hydraulic clutch?
Yes
Ford Probe distributor?
is there a diagram or a picture of the distributor cap and rottor in a 95 ford probe gt 2.5lt
What came as the stock engine in a 1994 Ford Probe GT?
stock enginestock engine in 1994 ford probe GT is a Mazda 2.5L 24 valve V6.
Can put a Ford Probe gt bumper on a Ford Probe base?
NO you can't because a ford probe Gt is a v6 while the ford probe base is a flat 4. Because of this the car is shaped differently including the bumper so you need to order a bumper for a base ford probe. this guy is wrong it is a direct bolt on and its inline 4 not flat 4
What transmissions and years are compatible with 1995 ford probe gt 2.5 6 cylinder turbo?
The 1995 Ford Probe, either the GT or the 4 cylinder DID NOT COME with a Turbo.
