The starter, on a 1994 Mazda Protege, is located on the driver's side of the engine. It is just behind and to the right of the oil fill cap.
where is the starter
Yes the 1994 Mazda Protege is a OBD 1 port
where is the modulator vavle on my 1994 Mazda protege dx?
aft side of the engine about the center bottom area.
No, it has motorized seat belts. The 1994 Protege is essentially the same car as the 1990 Protege, which is an economy car that cost about $10,000 new.
the starter is located between transmission and engine down intake manifold
There are two posts on the starter solenoid when the starter is in position the top one is for the positive battery cable. The bottom one should have a very short cable that enters the starter casing. I just replaced the starter in my 98 mazda protege yesterday.
crawl under your car and look in the rear of the engine.
Hi, starter is behind engine under the intake
The first Mazda Protege, also called the Mazda 323 and the Sixth Generation, was manufactured in 1989, and the car's production lasted for six years until 1994.
the alternator is located under the inlet manifold
that is the cooling fan relay.
Like any other wheel?
14.5 gallons AFAIK.
try going on ebay!
It is located on the bell housing between the engine and transmission.
6.5 inches. No screw patters match the protege, you'll have to drill alittle bit.
If a 1999 Mazda Protege keeps making clicking noises, you might have a bad alternator or starter. You could also have a bad ignition or solenoid.
The only tool that is really needed to remove the distributer cap off of 1994 Mazda Protege is a screwdriver. Using this tool will enable you to loosen the cap, and then you can remove it.
Were is the egr on a 1992 mazda protege
where is the thermostat on a 1999 mazda protege?
Have your Mazda dealer parts department print out a picture of the relays location for you. They will do this if you ask them.