Front right side next to exaust manifold lower right side of the engine block you must access it from the bottom of the blazer 2 bolts and a few shims Front right side next to exaust manifold lower right side of the engine block you must access it from the bottom of the blazer 2 bolts and a few shims
To change the starter on a 1998 s10, the motor mount will have to be removed. Support the motor on a jack with a board on the top of it, and remove the mount to get to the starter.
the starter relay.
The starter solenoid is attached to the starter.
It is attached to the starter.
An S2 starter is used when wiring 2 fluorescent tubes in series while S10 is used on a single tube
Typically, when the solenoid fails the starter is right behind. If you know how you could replace the solenoid, put in brushes and bushings and the starter MIGHT be ok if nothing bad has happened to the armature.
i just did a transmission change on a 90 s10 u probably have to drop gravel guard on transmission and starter should have two long bolts remove those and wiggle the starter out then carefully unbolt the two wires on the coil of the starter and be careful s10's usually have the two transmission lines in the way and those are a pain to replace hopes this helps and careful starter is heavy and u will prolly have to jack the vehicle up
You have a starter/ignition switch mounted in the steering column and you have a starter solenoid switch that is mounted to the starter.
check your answer
Follow the positive battery cable from the battery, it will lead you right to the starter.
The starter solenoid is attached to the starter.
will 2002 monte carlo rims fit 2000 s10