The Water Temperature Sensor Assembly is located in the thermostat housing. It's explicit location is shown as Ref #15 in the diagram listed in the 'Sources and Related Links' section of this answer. (located below)
It is plugged into the air intake just next to the intake manifold. Right next to the smallest hose connecting to the air intake.
The crankshaft sensor on a Rover 200 is located below and to the right of the generator and cylinder head temperature sensor. It is on the driver's side of the engine and above the oil filter.
Type your answer here... where is the position of Nissan pathfinder ATF temperature sensor
The temperature sensor provides feedback to the charger to allow the charger to determine when the battery is fully charged. The battery under charge develops internal heat as it approaches full charge. The temperature sensor measures the heat (temperature) and reports it back to the charger to end the charging cycle.
What type of coolant should acura rsx take
acura is built by Honda
audi or acura An Acura, an Austin-Healy
the map's purpose in a speed density type air/fuel management system (no mass airflow sensor) is to read intake manifold vacuum/pressure and help adjust fuel amount accordingly, along with inputs from other devices such as the throttle position sensor, engine coolant temperature sensor, and intake air temperature sensor.
Most vehicles use a temperature sensor and gauge that monitor the engine's coolant temperature. The gauge can either reflect the actual engine temperature (with a needle or a digital reading), or it could display a generalized temperature that informs the operator when the engine is at operating temperature or is dangerously hot. Many older vehicles (made before 1980) also used an engine block temperature sensor. The block sensor was usually impeded in the block and connected a warning light that illuminated when temperatures exceeded a certain amount. Most passenger vehicles did not use a gauge with this type of sensor. Some vehicles, especially those used for commercial and industrial purposes, use an oil temperature sensor. It works very much the same as a coolant sensor and can be placed in the engine, transmission, or both depending on the need. It would be more common for a warning light to be connected to this type of sensor, but there are aftermarket gauges that reflect accurate oil temperature readings.
how many quarts for a 2003 acura cl 3.2 type s how many quarts for a 2003 acura cl 3.2 type s
on a acura integra type r if you brake the head bolts what do you do on a acura integra type r if you brake the head bolts what do you do
The 2008 Acura MDX has single overhead cam (SOHC).