0
What else can I help you with?
Where is the cooling fan sensor on a 1989 323 Mazda and how do I check it engine heats up when I am stopped fine when moving.?
The thermo fan sensor is on the thermostat housing, right below the distributer.
Cps sensor 1989 Jeep Cherokee?
The camshaft position sensor is inside the distributor. The crankshaft position sensor is in the top of the bell housing on the driver side.
Replace 1989 Jeep Cherokee radiator fan switch where is it located?
The radiator fan switch on a 1989 Jeep Cherokee is located on the driver's side fender wall inside the engine compartment. It is a box about 1inch by 1inch just below the battery location.
Why does your 1989 Corolla with 2 barrel carb run fine after therm opens up but runs rich until then?
check the TVSV Thermo vacume switch valve.
Where is the speed sensor located on a 1989 jeep Cherokee Laredo?
Look on the back on the transfer case. There should be one wire running from it. That's your speed sensor. -- Blake.
94 Cherokee was running fine shut it off will turn over but just spins?
check for spark and fuel pressure I just had this problem with a 1989 Cherokee and had to have a Cranking Sensor installed.
Why will my 1989 jeep Cherokee Laredo headlights not go off?
sound like a bad dimmer switch hi/low beam
Will a 1996 Jeep Cherokee sport 4.0 go into a 1989 Jeep Cherokee sport with the 4.0?
It will bolt in, but the intake on the 1996 is different and the cylinder head on the 1996 does not have the temp sensor for the gauge in the same location.
How do you replace spark plugs in a 1989 Cherokee?
How to replace spark plugs in a 1989 jeep cherokee?
Where is the cold start sensor time switch on 1989 Toyota land cruiser?
The cold start sensor is the top sensor on the right side of the thermostat housing as you are looking at the engine from the front of the vehicle. It is 22mm.
Where is oxygen sensor located on 89 jeep Cherokee?
The Oxygen Sensor on a 1989 Cherokee 4.0L is on the exhaust pipe on the left side of the engine just below the exhaust manifold. You can see it from above but you must replace it from below. It is pretty easy to reach. I recently changed mine and it took only 10 minutes using an O2 sensor wrench.
You would love to find out where the high beam switch is on a 1989 Jeep Cherokee Pioneer?
Try pushing the turn signal lever forward, or pulling it toward you. This is a common location for the high beam switch.
