0
What else can I help you with?
How do you Change the thermostat in a 1997 suburban?
Where is the thermostat on a 1997 chevy suburban and how do you change it?
What is the cost to replace a thermostat in 1997 Chevy lumina?
100
How do you remove alternator from a 96 Chevy Montecarlo 3.4?
no
Where is the thermostat located on a 1997 Chevy Malibu?
Most stats are located in the thermostat housing at the bottom of the upper radiator hose.
Looking for location of thermostat on 1997 Chevy lumia?
it is in the housing on the engine where the upper radiator hose attaches
1997 montecarlo radio is locked?
You wcould try www.fordlockcodes.com and see if they can get the code for you...
How do you remove and replace thermostat on a 1997 Monte Carlo 3100 v6 engine?
Drain the water from your 1997 Chevy Monte Carlo cooling system. Remove the water supply hose. Remove the thermostat housing retaining bolts. The thermostat will lift out. Reverse the process to install the new thermostat.
Where is the thermostat located on a 1997 Chevy Venture V6?
follow the top radiator hose to the engine. its under the cover.
What should you look for if you are not getting heat in a 1997 Chevy S10?
Check your heater core and thermostat. The thermostat may be stuck open. Does the S10 run hot or cold?
How do you change thermostat on 1997 Chevy Lumina 3.1 engine?
To change the thermostat on a 1997 Chevy Lumina with a 3.1 engine, start by ensuring the engine is cool and disconnecting the negative battery cable. Drain the coolant from the radiator, then locate the thermostat housing, which is connected to the upper radiator hose. Remove the housing bolts, take out the old thermostat, and clean the mating surfaces before installing the new thermostat with a new gasket. Reassemble the housing, refill the coolant, and reconnect the battery.
Will Chevy s-10 rear end gears fit a 1985 Chevy montecarlo?
yes the gears from an s10 will fit in a Monte Carlo. most Chevy gears are interchangable
Where is the thermostat located on a 1997 Chevy Blazer?
located on the intake manifold just follow the upper radiator hose to the engine should be 2 bolts holding the thermostat housing down.
